STRAIGHT VAC UNITS


Straight Vac (unit displayed)
  • TC 407/412 and CSA B620-09
  • 17 Cubes 3740 Imp Gal +3% Outage
  • Full opening hydraulic rear door,Hoist cylinder and Vibrator
  • Full length subframe c/w Aluminum side deck/fender assembly, rear skirt and bumper
  • Robuschi RB-DV-85 PD High efficiency tri-lobe design Blower
  • 6" Plumbing, 6" Cyclone with clean-out door & heated drain valve
  • 6" brass load valve with 6" sandpipe D/S
  • Steel Vertical , deck cabinets & fitting boxes
  • D O T Lighting as required c/w L.E.D. work lights


Contact Leasing Agent

Standard Configuration 17 Cube Straight Vacuum Unit (Tri-Drive Mounted)


Design:  Vessel designed and constructed in compliance to Transport Canada TC407/412 CSA B620-09

Debris Tank:

  • Four reinforcement rings
  • 17 Cubes 3740 Imp Gal +3% Outage
  • 78 Diameter x 17"
  • Long 78" x 5/16
  • Heads 78" x 5/16" Shells
  • Three Rollover Bars
  • Tank Lock down assembly to meet current B620 Code
  • Reinforcing pads on all tank attachments
  • Pressure Vessel Hydro-tested to 40 PSI
  • Operating Temperature -20 deg F to 200 deg F
  • 3" x 30# PSIG Pressure Relief Vent 
  • Preformed angle pedestals
  • Prep Tank for Gallup Agitator
  • 8: heavy duty internal shut-off c/w 6" stainless steel floatball/cage and rubber seat and 6" flanged outlet
  • 6" Plumbing
  • Two 2" PRV'S in lower suction pipe
  • 6" Composite Loop Hose Vic Clamped
  • One Bolted Baffle
  • Full Opening Hydraulic Lift Rear Door with Safety Device c/w 6 pinwheel door locks
  • Rear door safety post P/S
  • 6" Brass Load Valve with 6" Sandpipe D/S
  • 4" Brass Load Valve P/S
  • 6" Brass Discharge Valve - Bottom Center of Rear Door
  • All rear valves heated and equipped with air/open, spring/close air actuators, separate flipper style control switches & aluminum camlocks
  • Recessed Stainless Steel Liquid Level Indicator - Grab Handle Style D/S
  • 6" Isolation Butterfly Valve - Air Control Switch at Operator Station
  • 6" Dip Port with Aluminum Camlock
  • 6" Cyclone with Clean-Out Door & Heated Drain Valve

Robuschi RB-DV-85 PD Vacuum Blower:

  • High Efficiency Tri-Lobe Design
  • 1600 CFM Free Air Rating
  • 27" Hg Maximum Vacuum
  • Oil Free Operation (Except Sealed Reservoirs)
  • Blower Clearance & Timing Inspection Prior to Installation
  • 6" Four-Way Diverter Valve (Vacuum to Pressure Modes)
  • 6" Double Door Check Valve (To Prevent Blower Back Spin)
  • 16" Dia. x 20 Micron Rating (Washable) Pre-stage Blower Filter Approved Design
  • High Torque/High Temp Blower Drive Coupling with Flexible Insert
  • One Exhaust Silencer, One Intake Silencer

P T O:

  • 8-Bolt P.T.O. (Greaseable Shaft Seal)
  • Air Shift Control & Hour Meter in Control Box by Driver's Seat

Hydraulic System (Linde Closed Loop Design):

  • Hydraulic Pump (Direct Mount to PTO)
  • Hydraulic Motor (Direct Mount to Blower)
  • Multi-function Hydraulic Control Bank
  • Variable Speed Joystick, for Blower Operation
  • Torque control for vac pressure
  • 90 Imperial Gallon Hydraulic Oil Reservoir (Cleaned, Purged & Air Tested Prior to Installation) c/w (10 Micron) In tank Filter, Breather fill cap, Temperature & Level Indicator and inspection hatch
  • Global Hydraulic Vibrator with Flow Control Valve
  • One 12 Volt  Oil Cooler
  • Mailhot 3-Stage Hydraulic Dump Cylinder
  • Double Acting Rear Door Hydraulic Cylinder with Safety Counter Balance Valve
  • Hydraulic Hose And Fittings As Required

 

Oil River Equipment Inc.

Vacuum Truck Rental information
Call: 780-979-0669

 

© 2018 - Oil River Equipment Inc. 1807- 4A St. Nisku, Alberta. Canada T9E 7V3