16 CUBE STIFF POLE PUP


16 Cube Stiff Pole Pup Vacuum Trailer  - Standard Unit Configuration

Base Model - Unit displayed above may differ for the standard configurations.
Please contact a sales representative for more details about the unit listed above.

Design: Vessel to be designed and constructed in compliance with Transport Canada Spec TC407-412, CSA B620-09.
Meets requirements of Section VIII, Division 1 of the ASME Boiler and Pressure Vessel Code



Contact Leasing Agent

 

16 Cube Stiff Pole Pup Vacuum Trailer


Debris Tank (16m3 ( 3520 Imp Gal +3% Outage):

  • Three reinforcement rings
  • Three Rollover Bars
  • Reinforcing pads on all tank attachments
  • Pressure Vessel Hydrotested to 40 PSI
  • 3" x 30 PSI Pressure Relief Vent
  • 78" Diameter ( 16' seam to seam )
  • 5/16" Shells
  • 5/16" F & D Heads
  • Preformed angle front and rear pedestals
  • Tank lock down assembly to meet current B620-09 Code
  • 8" heavy duty internal shut-off c/w 6" stainless steel floatball/cage, rubber seat assembly and 6" flanged outlet
  • 6" Dip Port c/w aluminum camlock/cap
  • 6" Plumbing
  • 6" composite Loop Hose Vic Clamped
  • One Bolted Baffle
  • Full Opening Hydraulic Lift Rear Door c/w 6 Pinwheel Door Locks
  • Rear Door Safety Post P/S
  • Two Snorkle Style 6" Brass gate valves ,air actuated c/w S S camlocks mounted on  Front Head Drivers Side
  • 6" Brass gate Valve c/w 6" Sandpipe, D/S rear door
  • 4" Brass gate Valve P/S rear door
  • 6" Brass Discharge Valve Bottom Center of Rear Door
  • All rear valves  heated and equipped with air/open,spring/close actuators & separate control switches
  • Recessed Stainless Steel Liquid Level Indicator - Grab Handle Style D/S
  • 6" (Self Closing) Isolation Valve" Air Control Switch at Operator Station
  • 6" Cyclone with Clean-Out Door & Heated Drain Valve mounted off trailer frame D/S
  • 2" Pressure Relief Valve in lower  Vac/Pressure Piping
  • Operating Temperature -20 deg F to 200 deg F

 

Hydraulic System:

  • Hydraulic Control Bank System for hoist.rear door and vibrator.
  • Global Hydraulic Vibrator with Flow Control Valve
  • One 12 volt Oil Cooler
  • Mailhot 3-Stage Hydraulic Dump Cylinder
  • Double Acting Rear Door Hydraulic Cylinder with Safety Counter Balance Valve
  • Hydraulic Hose and Fittings as required

Frame Unit, Decking & Trim:

  • Trailer-Frame supports decking, Rear Hoist Hinges & Front Hoist Cradle
  • Full Length 1/8" checker deck/fender assembly with Heavy Duty Outrigger Supports, 1-1/4" HSS Steel Tubing Handrails, Close in Plates, Rear Tire Skirt
  • Steel light box modules d/s & p/s
  • Code Rear Bumper with Platform Step  and rear skirting

Toolboxes:

  • One Steel 60" Deck Tool Box D/S
  • One steel fitting Box D/S
  • Two Skirt Fitting Boxes

Electrical System:

  • Waterproof Main Circuit Control Box Self Contained Power Supply
  • Sealed Wire Harness c/w Waterproof Junction Boxes
  • L.E.D. lamps (Clearance, Park, Signal)
  • Sealed LED Reverse Lamps
  • NOTE: LIGHTS ARE DUAL REVOLUTION & ALL BOTTOM  RED LIGHTS TURN WHITE WHEN IN REVERSE
  • Four L.E.D. work lights
  • Electrical System Shut-Down at Key
  • Sealed Rear Skirt Lamp Modules
  • Stop & Turn L.E.D. Sealed Lamp Modules on Top Ring of Rear Door
  • Back-Up Alarm

Additional Items:

  • Two Slide Out Style Tire Chain Racks
  • 30lb Fire Extinguisher c/w Mounting Bracket & Cover
  • Four multi pin Placards
  • Mudflaps as required
  • 50' ground cable
  • One Operators Manual supplied with unit
  • National Safety Mark

 

 

Oil River Equipment Inc.

Vacuum Truck Rental information
Call: 780-979-0669

 

© 2018 - Oil River Equipment Inc. 1807- 4A St. Nisku, Alberta. Canada T9E 7V3